Diamond Honing Guide |
|
Fast, foolproof and set-up time is zero ( 4 Customer Reviews )
|
|
Any bevel edged cutting tool can be sharpened or finish honed rapidly. Just insert the blade in the side of the jig (as shown), against either the front or back stop, and stroke the sliding section back and forth. One side hones at an angle of 25° and the other at 30°. No practice is required. Rubber feet give it exceptional stability.
Carriage runs smoothly on Nylon 66 slip rails.
Comes with 220 and 450 grit plates as standard. Sharpens square-edged chisels and plane blades from 1/8" (3 mm) to 2-1/2" (64 mm) wide.
Click Here or scroll down for more information and PDF instruction manual.













( 








©2012 Garrett Wade